Voltlog #177 – Installing BLTouch Auto Bed Leveling On The Creality CR-10 3D Printer

Today I’m gonna show you how I installed a bltouch sensor on my creality CR10 3d printer. But first to give you a bit of info, if you are a frequent viewer of the channel than you know I have tried a bunch of different sensors, inductive, capacitive but they either didn’t have enough sensing distance to cover the glass I’m using on top of the aluminium bed or they weren’t giving me repeatable results so they all ended up disconnected.

I had a bunch of adhesion problems because I couldn’t level the bed properly, my bed doesn’t look very good, in fact I’m gonna overlay a picture of my bed after the auto bed leveling has been installed and you’ll see it’s far from being flat so it was really difficult for me to print something that was bigger than a couple of cm’s because the bed wasn’t flat.

Then I found this bltouch sensor or more correctly a clone of the bltouch sensor on aliexpress for just $14 and I said why not, let’s try this one as well and ordered one. And boy was I impressed how much better the printing got after installing it.