Month: February 2019

Voltlog #211 – Joulescope DC Energy Analyzer Review & Teardown

Welcome to a new voltlog, today I’m excited because we’re going to take a look at an awesome piece of instrumentation. I’ve received a pre-production demo unit of the Joulescope DC Energy Analyzer.

The joulescope is a low cost precision dc energy analyser which is currently on kickstarter so check the links in the description of the video for the kickstarter campaign because it has a massive discount from the retail price. The joulescope has circuitry for measuring voltage and current, from which it can calculate power and then it can integrate power over time to calculate energy. The current measurement range is from 10A al the way down to 1nA, that’s a huge dynamic range which makes it very useful if you plan to measure the energy consumption of a device that has mixed behavior for example an esp32 that will wake up, do some activity and then go back to deep sleep.

The joulescope works with a software companion that has a multimeter view and an oscilloscope view which I find very useful because it will allow you to time correlate measurements of voltage and current. That can be extremely useful when determining the energy usage of your device.

Voltlog #210 – 946C Hot Plate Review & Teardown

Welcome to a new Voltlog, today we’re gonna do a review and teardown of this hot plate which was supplied for free by banggood.com. So you would use something like this to preheat a pcb, to prepare it for desoldering an IC or even for reflow soldering a board. As usual there will be links placed in the description below which I encourage you to check out. There is a 100x100mm version at 400W and a 200x200mm version which I have here at 800W.

If you haven’t worked with a multi layer pcb you might ask yourself why do I need to pre-heat the board. Well modern devices uses a high number of internal pcb layers so desoldering something from those might be harder if you only heat the board from the top with hot air, it might take some time until the IC reaches desoldering temperature because the heat is sucked away by the internal copper layers.

This could be bad for the board and the IC because you will need to increase the temperature of your hot air station above the normal working temperature to compensate for that and in the process you might damage the board or the IC. Such a tool allows you to bring the board to a higher temperature without creating any hot spots, and then you can just heat with hot air from the top the are where you need to work.

Voltlog #209 – Cheap Electric Desoldering Pump Teardown

Welcome to a new Voltlog, today we’re doing a teardown of this electric desoldering pump, which I showed in a previous mailbag video. This had a major when I powered it one, in fact I’m not gonna try to power it on again because I don’t want all that smoke to fill-up my lab again.

Voltlog #207 – Making a DIY Spot Welder From A Microwave Transformer

Welcome to a new voltlog, today I’m gonna talk about a DIY spot welder that I built, the advantages of suck a build as well as the disadvantages or the the problems I encountered. So the idea for this project started many months ago, I was actually at a local recycling center to deposit some old electronics, when I saw this microwave oven transformer sitting right there on a table, like the guy in charge of the place literally took the transformer out of a microwave oven a few hours prior to me arriving there.

So that sparked the idea in my head, I asked the guy if I can have the transformer, he said yes and that was the start.